Store is under MAINTANANCE. No orders will be fulfilled.
GW Instek's MSO-2204EA is suited with all the advantages of the MSO-2202EA Digital Storage Oscilloscope, but delivers users with 4 channels and a maximum 1 GSa/s sample rate.
View GW Instek's MSO-2202EA Oscilloscope here.
*Quick start guide, user manual CD, 1 power cord, 1 GTL-16E 6-channel logic analyzer probe and 1 (per channel) GTP-200B-4 switchable passive probe included.
|
Channels |
4ch |
|
Bandwidth |
DC~200MHz |
|
(-3dB) |
|
|
Rise time |
1.75ns |
|
Bandwidth Limit |
20M/100MHz |
|
Vertical Sensitivity |
|
|
Resolution |
8 bit |
|
:1mV~10V/div |
|
|
Input Coupling |
AC, DC, GND |
|
Input Impedance |
1MΩ// 16pF approx. |
|
DC Gain Accuracy |
±(3%)when 2mV/div or greater is selected
±(5%)when 1mV/div is selected; |
|
Polarity |
Normal & Invert |
|
Maximum Input Voltage |
300Vrms, CAT I |
|
Offset Position Range |
1mV/div ~ 20mV/div : ±0.5V |
|
50mV/div ~ 200mV/div : ±5V |
|
|
500mV/div ~ 2V/div : ±25V |
|
|
5V~10V/div : ±250V |
|
|
Waveform Signal Process |
+, -, ×, ÷, FFT, FFTrms ,User Defined Expression. |
|
|
FFT:1Mpts |
|
Trigger |
|
|
Source |
CH1 ,CH2, CH3, CH4, Line, EXT* |
|
*dual channel models only |
|
|
Trigger Mode |
Auto (supports Roll Mode for 100 ms/div and slower), Normal, Single Sequence |
|
Trigger Type |
Edge, Pulse Width(Glitch), Video, Pulse Runt, Rise & Fall(Slope), Alternate,tme out, Event-Delay(1~65535 events), Time-Delay(Duration,4nS~10S), Bus |
|
Holdoff range |
4ns~10s |
|
Coupling |
AC,DC,LF rej. ,HF rej. ,Noise rej. |
|
Sensitivity |
1div |
|
External Trigger |
|
|
Range |
±15V |
|
Sensitivity |
DC ~ 100MHz Approx. 100mV |
|
100MHz ~ 200MHz Approx. 150mV |
|
|
Input Impedance |
1MΩ±3%~16pF |
|
Horizontal |
|
|
Time base Range |
1ns/div ~ 100s/div (1-2-5 increments) |
|
ROLL: 100ms/div ~ 100s/div |
|
|
Pre-trigger |
10 div maximum |
|
Post-trigger |
2,000,000 div maximum. |
|
Time base Accuracy |
±50 ppm over any ≥ 1 ms time interval |
|
Real Time Sample Rate |
Max.:1GSa/s |
|
Record Length |
Max:10Mpts |
|
Acquisition Mode |
Normal, Average, Peak Detect, Single |
|
Peak Detection |
2ns (typical) |
|
Average |
selectable from 2 to 256 |
|
X-Y Mode |
|
|
X-Axis Input |
Channel 1; Channel 3 |
|
Y-Axis Input |
Channel 2; Channel 4 |
|
Phase Shift |
±3° at 100kHz |
|
Cursors and Measurement |
|
|
Cursors |
Amplitude, Time, Gating available; Unit:Seconds(s),Hz(1/s) ,Phase(degree) ,Ration(%) |
|
Automatic Measurement |
36 sets: Pk-Pk, Max, Min, Amplitude, High, Low, Mean, Cycle Mean, RMS, Cycle RMS, Area, Cycle Area, ROVShoot, FOVShoot, RPREShoot, FPREShoot, Frequency, Period, RiseTime, FallTime, +Width, -Width, Duty Cycle, +Pulses, -Pulses, +Edges, -Edges, FRR, FRF, FFR, FFF, LRR, LRF, LFR, LFF, Phase ,Cursor measurements |
|
Control Panel Function |
|
|
Auto counter |
6 digits, range from 2Hz minimum to the rated bandwidth |
|
Autoset |
Single-button, automatic setup of all channels for vertical, horizontal and trigger systems, with undo Autoset |
|
Save Setup |
20set |
|
Save Waveform |
24set |
|
Display |
|
|
TFT LCD Type |
8" TFT LCD WVGA color display |
|
Display Resolution |
800 horizontal × 480 vertical pixels (WVGA) |
|
Interpolation |
Sin(x)/x |
|
Waveform Display |
Dots, vectors, variable persistance (16ms~4s), infinite persistance |
|
Waveform Update Rate |
120,000 waveforms per second, maximum |
|
Display Graticule |
8 x 10 divisions |
|
Display mode |
YT ;XY |
|
Interface |
|
|
USB Port |
USB 2.0 High-speed host port X1, USB High-speed 2.0 device port X1 |
|
Ethernet(LAN) Port |
RJ-45 connector, 10/100Mbps with HP Auto-MDIX |
|
Go-NoGo BNC |
5V Max/10mA TTL open collector output |
|
Kensington Style Lock |
Rear-panel security slot connects to standard Kensington-style lock. |
|
Logic analyzer specifications |
|
|
Sample Rate |
Per Channel 1GSa/s |
|
Bandwidth |
200MHz |
|
Record Length |
Per Channel 10M pts (max) |
|
Input Channels |
16 Digital (D15 - D0) |
|
Trigger type |
Edge, Pattern, Pulse Width, Serial bus (I2C, SPI, UART(RS232/422/485), CAN, LIN), Parallel Bus |
|
Thresholds Quad |
D0~D3, D4~D7,D8~D11 ,D12~D15 Thresholds |
|
Threshold selections |
TTL, CMOS(5V,3.3V,2.5V), ECL, PECL,0V ,User Defined |
|
User-defined Threshold Range |
±5V |
|
Maximum Input Voltage |
±40 V |
|
Minimum Voltage Swing |
±250 mV |
|
Vertical Resolution |
1 bit |
|
AWG Specifications |
|
|
Channels |
2 |
|
Sample Rate |
200 Msa/s |
|
Vertical Resolution |
14 bits |
|
Max. Frequency |
25 MHz |
|
Standard Waveform |
Sine, Square, Pulse, Ramp, DC, Noise |
|
Built-in ARB Waveform |
Sinc, Gaussian, Lorentz, Exponential Rise, Exponential Fall, Haversine, Cardiac |
|
Output Range |
20 mVpp to 5 Vpp, HighZ;10 mVpp to 2.5 Vpp, 50 Ω |
|
Output Resolution |
1mV |
|
Output Accuracy |
2% (1 kHz) |
|
Offset Range |
±2.5 V, HighZ;±1.25 V, 50 Ω |
|
Offset Resolution |
1mV |
|
Sine |
|
|
Frequency Range |
100mHz to 25MHz |
|
Flatness |
±0.5 dB( relative to 1kHz) |
|
Harmonic Distortion |
-40 dBc |
|
Stray (Non-harmonic) |
-40 dBc |
|
Total Harmonic Distortion |
1% |
|
S/N Ratio |
40 dB |
|
Square/Pulse |
|
|
Frequency Range |
100mHz to 15MHz |
|
Rise/Fall time |
<15ns |
|
Overshoot |
<3% |
|
Duty cycle |
Square:50%;Pulse:0.4%~99.6% |
|
Min. Pulse Width |
30 ns |
|
Jitter |
500 ps |
|
Ramp |
|
|
Frequency Range |
100mHz~1MHz |
|
Linearity |
1% |
|
Symmetry |
0 to 100% |
|
Miscellaneous |
|
|
Multi-language menu |
Available |
|
operation environment |
Temperature: 0°C to 50°C. Relative Humidity ≤ 80% at 40°C or below; ≤ 45% at 41°C ~ 50°C. |
|
On-line help |
Available |
|
Time clock |
Time and Date ,Provide the Date/Time for saved data |
|
Dimensions |
384mmX208mmX127.3mm |
|
Weight |
3kg |
Write Your Own Review
- Educational Courses
- Automotive Electronics
- ICT Product Design
- Embedded Circuit Design
