|
| | |
|
| |
| | |
|
|
Signal Isolators
The loop-powered isolator, CLI22, is used for electrical isolation of 0(4)-20 mA signals to avoid measurement errors due to different voltage potentials or ground loops in an instrument installation.
|
IsoPAQ-110L is a loop powered isolator, available in 1- and 2-channel versions. It is used for electrical isolation of 0(4)-20 mA signals to avoid measurement errors due to different voltage potentials or ground loops in an instrument installation.
|
The Sineax TI-816 isolates 4-20mA loop signals, uses no power and mounts on any DIN rail.
|
|
|
IsoPAQ-21L and IsoPAQ-22L are 1- and 2-channel loop powered isolators used for electrical isolation of 0(4)-20 mA signals to avoid measurement errors due to different voltage potentials or ground loops in an instrument installation.
|
Thanks to the programmable input range and the low input impedance, IPAQ-L(mA) meets almost any need for current signal isolation and load amplification.
|
IsoPAQ-11L and IsoPAQ-12L are 1- and 2-channel loop powered isolators used for electrical isolation of 0(4)-20 mA signals to avoid measurement errors due to different voltage potentials or ground loops in an instrument installation.
|
|
The Isolation Transmitter IsoPAQ-131P is used for isolation andconversion of 0-20 mA, 4-20 mA and 0-10 V unipolar signals.
|
The JH Technology Model JH4300C Process Current Isolator takes a 4/20mAdc input and provides an equal but isolated 4/20mA output. Isolation eliminates many ground loop and noise problems, while its 24-volt output drive capability “boosts” the si
|
IPAQ-4L is a fully universal and programmable 4-wire (separately powered) transmitter.
|
The Isolation Transmitter IsoPAQ-161P is mainly used for isolationof bipolar signals, such as +/-20 mA, +/-10 mA, +/-10 V, +/-5 V, andconversion into unipolar output signals.
|
The high accuracy and reliability and the Protective Separation are further features, which ensure a safe system operation.
|
| |
|
|
|